Speakers (THD+N< 0.4%) Load, 75 \x96 85%PowerPAD is a trademark of Texas Instruments.
The TPA2001D2 is the third generation 5-V class-D amplifier from Texas Instruments. Improvements to previous generation devices include: lower supply current, lower noise floor, better efficiency, four different gain settings, smaller packaging, and fewer external components. The most significant advancement with this device is its modulation scheme that allows the amplifier to operate without the output filter. Eliminating the output filter saves the user approximately 30% in system cost and 75% in PCB area.
The TPA2001D2 is a monolithic class-D power IC stereo audio amplifier, using the high switching speed of power MOSFET transistors. These transistors reproduce the analog signal through high-frequency switching of the output stage. The TPA2001D2 is configured as a bridge-tied load (BTL) amplifier capable of delivering greater than 1 W of continuous average power into an 8- load at 1 kHz, the typical
THD+N is less than 0.08%.
A BTL configuration eliminates the need for external coupling capacitors on the output. Low supply current of 8 mA makes the device ideal for battery-powered applications. Protection circuitry increases device reliability: thermal, over-current, and under-voltage shutdown.
Efficient class-D modulation enables the TPA2001D2 to operate at full power into 8- loads at an ambient temperature of 85°C.
| Type | Title | Date | ||
|---|---|---|---|---|
| * | Data sheet | 1-W Filterless Stereo Class-D Audio Power Amplifier datasheet (Rev. A) | 25 Apr 2000 | |
| Application note | Layout Guidelines For TPA300x Series Parts (Rev. A) | 24 Jun 2020 | ||
| Application note | Measuring Class-D Amplifiers for Audio Speaker Overstress Testing | 28 Oct 2005 | ||
| EVM User's guide | TPA2001D2EVM - User Guide | 01 Nov 2000 |
For additional terms or required resources, click any title below to view the detail page where available.
The TPA2001D2 is a stereo Class-D audio power amplifier that does not require an output filter. The TPA2001D2 has an output power of 1-W RMS into 4 Ohm speakers. By eliminating the need for bulky LC output filters, the TPA2001D2 audio power amplifier enables designers to reduce board space and (...)
| Package | Pins | Download |
|---|---|---|
| HTSSOP (PWP) | 24 | View options |
Content is provided "as is" by TI and community contributors and does not constitute TI specifications. See terms of use.
If you have questions about quality, packaging or ordering TI products, see TI support.